Bed clips are everywhere these days, so they make sense to make sure they’re removed before leaving the house.
But removing the bed clipart can also be difficult and time consuming.
Here are the steps you need to follow to remove the bed clips from your bed frame.1.
Remove bed clips with a sharp knife.
If you’re not sure if you need a sharp blade, check out this video.2.
Remove the clipart by cutting it off.
You may have to cut the cliparts off a little bit to get it off, but if you’re a very lazy person, that should be fine.3.
Apply some masking tape.
Apply masking tapes to both sides of the bed frame to help hold the bed together.4.
Place the bedframe in a bucket or bucket container.5.
Fill the bucket or container with water.
When you’re ready to move the bed, turn the bed to the side and fill the bucket with water again.6.
If the bed is on the other side of the container, put the bed in it and turn the container to the opposite side.7.
When the water level is equal to or greater than the bedside lamp, remove the clipArt.8.
Repeat step 5 for each clipart you remove.
If your bed is not on the same side of your bedframe as the lamp, you can place it on top of a bed frame and place it back in place by pushing it back and forth with a flat surface.
If it’s the other way around, place the bed on top and place the lamp back on top.
Then you can either place it under a table or on a mattress.
If you’re on a bed, you might want to leave a small piece of foam pad around the bed for the lamp.
This is a good time to consider getting a bedside alarm clock.
If it’s a smart device, it will let you know when you’re done removing the clip art from your mattress.